Velleman-projects K4040 Assembly instructions Uživatelský manuál stáhnout pdf (Strana 15)

 Check that the solder side of the PCB, is along the side of the nuts.

 Solder a 35 cm length of yellow wire to the 4 Ohm connection (YEL).

 Solder a 35 cm length of red wire to the 0 connection (RED).

 Fit the unit onto the housing with three black Allen bolts, fix with a shakeproof washer and nut.

 Mount the mains voltage connector to the housing using two black Allen bolts.

 Solder a 12 cm length of blue wire to the N terminal of the mains connector.

 Solder a 12 cm length of brown wire to the L terminal of the mains connector.

 Solder a 20 cm length of yellow/green earth wire and a 12 cm length to the middle terminal of the

mains connector.

 Slide a 1.5 cm length of insulating heat shrink sleeve over each terminal all the way up the con-

nector. This can be shrunken by hot air (e.g. with a hair dryer).

 IMPORTANT: Stick a piece of insulating foil on the connector, see figure 4.0. This will later be

used to prevent the connector piercing through the transformer.

 Also stick a piece of insulating foil on the inside edge of the cabinet above each place where a

transformer has to be put (see fig. 6).

 HINT: In order to tighten the nuts well, immobilise the loudspeaker terminal by inserting a

screwdriver through the hole for the loudspeaker lead.

 IMPORTANT: The loudspeaker terminals must NOT touch the metal cabinet anywhere.

ADHESIVE PROTECTION FOIL

Fig. 4.0

Assembly into the unit

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Žádné komentáře

Velleman-projects K4040 Assembly instructions Uživatelský manuál Strana 15