Velleman-projects K8200 Short user manual Uživatelský manuál stáhnout pdf (Strana 2)

- 3 -- 2 -

VELLEMAN-KIT

3D Printer kit

Order code: K8200

manufactured by:

VELLEMAN NV.

Legen Heirweg, 33

9890 Gavere

Belgium

CE conformity information:

The K8200 is a DIY 3D printer kit, it contains all the bits and pieces to construct your own 3D printer but does not contain

additional protection.

As it is a kit and not a nished product, compliance with the CE regulations depends on the build-quality; also the following

notes must be taken into account.

Conductive EMC towards the public distribution network is not an issue as this is related to the power supply.

Radiated EMC depends substantially on the build quality, it might be required to add shielding but this cannot be predicted.

A built K8200 should comply with EN50081 normation

Electromagnetic radiation (EMC):

The included power supply meets all the applicable European requirements and bears the CE-mark.

It is protected against overload and short circuit and nothing needs to be modied. The working voltage of the 3D printer is

15Vdc (extra low voltage) and therefore it’s outside the scope of the Low voltage directive.

Always unplug before maintenance or modication.

Electrical safety:

Important safety instructions

��

1 2 3 4 5 6 7 ... 15 16

Žádné komentáře

Velleman-projects K8200 Short user manual Uživatelský manuál Strana 2